Clothing fire with flammable occasions prone to fire or presence of a fire. Applies within a specific time to enter the scene of the fire.
Wearer from the flame close, might want to direct contact with the flames, rescue or fire fighting work place very close to the flame.
Note: firefighting clothing wearing is no specific time limit relief work wearing time depends on a variety of factors, such as: environmental factors, the wearer's fatigue level. In all of the work process can use a respirator. In the case of not equipped with respirators, it is necessary to try to shorten the wearing time of the retardant clothing, because of air inhaled oxygen just retardant clothing contained inside. Should you notice the inside temperature of the flame-retardant suits increased too much, you will need to immediately evacuate the work area, retreat to a safe area and open retardant clothing, until the temperature returns to normal.
If firefighting clothing, appearance or other damage will have to quickly withdraw from the work area, change into the same fire-retardant clothing ready. Who does not have all kinds of anti-chemical, electrical risk guarantees additional equipment shall not be used for the purposes described in this manual.
Note: flame-retardant suits the wearer only play appropriate protective role, the scope of its protection, including the interior of the flame-retardant suits. In case the wearer to improve the level of protection of the flame-retardant clothing, you can wear a higher thermal insulation and fire resistance within retardant clothing (the commercial Code: 140037). It includes a long-sleeved mesh shirt, stockings, gloves and Alpine hat. Safety shoes should be supporting and B2 flame retardant clothing sets of shoes or boots worn by staff, as is the safest (in accordance with the requirements of the European standard EN345) heat resistant soles.
In accordance with the actual risk situation, wearable line with European standard EN346 or EN347 shoes or boots.
Each wearing firefighting clothing to be checked to determine the fire-retardant clothing and components are intact, you must complete and clean. Incomplete, flame-retardant clothing and components (for example: eyepiece gilded surfaces soiled clothes open line rupture or perforation, etc.), will have to avoid the use of absolute. The big vision goggles should be complete, and is positioned at the assembly slots. The gilded surface should be clean and should not have any scratches, so as not to interfere with the line of sight. If the wearer that the use of goggles in poor condition, and should be replaced.
Only when the firefighting clothing and its components under normal wear and installation conditions and remain intact, only to have the safety features.